What are the best camera settings for Milky Way photography?

What are the best camera settings for Milky Way and astrophotography? I offer this and some tips to make it easy for you.

Is offering camera settings meaningless?

Double Arch, Arches National Park, Milky Way
Double Arch in Arches National Park in Utah. Camera settings are 20 seconds, f/2.8, ISO 4000.

Some night photographers argue that offering camera settings for Milky Way photography is useless. In a way, they’re right. There are so many variables.

For instance, it depends on what kind of lens. The larger the aperture the lens has, the more light it lights in. The wider the focal length, the longer the amount of time you can set your camera’s exposure length. Then there are atmospheric variables, light pollution and more that affect the settings.

A discussion about settings could take up quite a lot of space in a book. However, I’ll try and give you starting points.

Assumptions before giving camera settings

To stop the variables from spinning out of control, we are going to assume that you have a relatively modern digital camera and an ultra wide-angle lens with a focal length of about 14mm or 15mm since that seems to be the most commonly used. We will also assume that you are not using a star tracker, and that your camera is simply mounted on a tripod.

Starting camera settings for Milky Way photographs

I like to begin with a 20-second exposure, an aperture of f/2.8 and ISO of 3200 or 4000. 

Exposure

20-second exposures are typically long enough to gather light, but short enough that your stars register as relative pinpoints of light. If you can reduce this further, great. If not, this should be a good starting point for a lens with a focal length of 14mm or 15mm.

Aperture

If your lens has a larger aperture than f/2.8, such as f/2.0 or f/2.4, try to use it. However, some lenses have distortion in the corners if you photograph “wide-open” (at the largest aperture). Look for things such as “angel wings” or UFO-looking stars in the corners.

If there are none, great. If there are, reduce the aperture back to f/2.8 or until that stops.

ISO

Boosting the ISO to 3200 or 4000 should be bright enough to adequately capture the Milky Way without blowing out the highlights.

Arch with Milky Way, Mojave Desert, Southwest US.
A hidden arch in Mojave Desert, Southwest US. This is admittedly “stacked.” However, the settings for the sky are 15 seconds, f/2.5, ISO 4000. I was able to drop the exposure down to 15 seconds because my lens could be opened up to f/2.5.

Adjusting from the beginning camera settings

Just like you would with a day photograph, all your camera adjustments are the same. 

“My image is too dark!”

This is the most common thing people encounter. If your image is too dark, you can make it brighter by lengthening the exposure, opening the aperture (if that’s possible), and/or increasing the ISO. 

Each has trade-offs, of course. Sometimes, lengthening the exposure might turn your stars as pinpoints into elongated trails. Or increasing the ISO might introduce more noise into your image, although you could address that in post-processing by using Topaz Labs DeNoise AI or other noise reduction software. I’ve had good luck using this software for Milky Way photos without decreasing the sharpness and detail of the Milky Way.

“My image is too bright!”

This is less common with Milky Way photos, but can occur more frequently when doing star trails or photographing near a full moon. 

You can decrease the exposure time, make the aperture smaller and/or decrease the ISO.

Further information

write a lot about night photography here. When you see a night photo, you can click on the image and see what the camera settings were. You can learn a lot from these by looking at the image, trying to figure out what the ambient light was, and figure out why that setting was chosen.

After seeing a number of photos, you can also begin to see patterns emerging and begin to figure out why certain settings are chosen over others.

VISIT ME, VISIT ME!

BOOKS AND PRINTS:
Head on over to the Ken Lee Photography website to purchase books or look at night photography and long exposure prints and more.  My books are available there and Amazon, Barnes and Noble, Target, Booktopia, Books A Million, IBS, and Aladin. If you enjoy the book, please leave a nice review, thanks!

NIGHTAXIANS VIDEO YOUTUBE PODCAST:

Night photographers Tim Little, Mike Cooper and I all use Pentax gear. We discuss this, gear, adventures, light painting, lenses, night photography, creativity, and more in this ongoing YouTube podcast. Subscribe and watch to the Nightaxians today!

SOCIAL MEDIA:
Ken Lee Photography Facebook Page (poke your head in, say hi, and “like” the page if you would, uh, like)
Instagram

PODCAST:
Behind the Shot video podcast – interview February 2020

VIDEO PRESENTATION:

How We Got the Shots: Five Photographers, Five Stories – Night Photo Summit 2022

VIDEO INTERVIEW:

Ken Lee’s Abandoned Trains Planes and Automobiles with Tim Little of Cape Nights Photography
Conversation about night photography and my book with Lance Keimig of National Park At Night

ARTICLES:
A Photographer Captures Haunting Nighttime Images of Abandoned Buildings, Planes, and Cars in the American Southwest – Business Insider by Erin McDowell
A Photographer Explores Southern California’s Desert Ruins – Los Angeles Magazine article by Chris Nichols

 

Advertisement

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s